#Automation game engine guide full

Pressing the directional key in the opposite direction ( S or W) of travel will engage engine brakes.

Trains have two different braking systems: Holding the forward or backward directional key will begin 'revving up' the engines, slowly increasing the power consumption until the motors generate enough torque to overcome its weight and the train begins to accelerate in that direction. However, the railway beneath it can be dismantled and the train will abruptly halt and remain floating in the air.Д®ntering a train with auto-pilot disabled will allow you to drive it manually. Engines or cars can be added even when the train is moving, but only by the host in multiplayer games.ДЄ locomotive cannot be dismantled while it is moving or on an automatic schedule, only when it is completely stationary and auto-pilot is disabled. There is no way to edit the middle of a train the only way to edit the middle of a train is to dismantle the whole thing and rebuild it in the new layout.

Sometimes the blueprint will not look like it is snapping, but building the engine or car anyways will still connect it to the rest of the train if it is close enough that it should snap. To add more locomotives or freight cars to the train, simply aim at the railway in front of or behind the train and the blueprint will usually snap in place. Thus they can be freely built on a slope and will eventually come to a stop if you jump out of a moving train with no auto-pilot. Locomotives automatically engage the brakes when there is no driver.

#Automation game engine guide full

Every engine always provides full torque regardless of the direction of travel. For example, a train with three engines facing forward can only drive forward with auto-pilot and requires a loop at the end of the line to turn around a train with the first and last engine facing forward and the middle engine facing backward can still only travel forward a train with the front two engines facing forward and the last engine facing backward can be automated in both directions and no longer needs to turn around. However, auto-pilot can only travel in a given direction if there is at least one engine at the front of the train.

When driving a train manually, you can travel at full speed both forward and backward regardless of the position or direction of the locomotive within the train. The face with the windshield is the front and the side with six motors in the rear. For example, when driving a train with four engines and drawing the maximum load of 110 MW, you are actually consuming 440 MW total.ДЄ locomotive can only be constructed on a railway. Note that the power consumption shown in the HUD is multiplied per engine on that train. A locomotive cannot accelerate unless the railway is powered, but it can always use its brakes. Likewise, it will automatically dial back the power consumption when under less strain, dropping to its minimum 25 MW when going downhill. It may draw up to 110 MW when accelerating, with the exact amount depending on how much 'strain' the engine is under for example, it will use more power when climbing a hill than on a level track. The Electric Locomotive requires a minimum of 25 MW to operate at all times, even when stationary or docked at a Train Station.

5.3 Round trip time versus train length.